EQUALIZER BAR ASSEMBLY REPLACEMENT - TM-5-2410-233-230519

TM 5-2410-233-23

EQUALIZER BAR ASSEMBLY REPLACEMENT

0108 00

THIS WORK PACKAGE COVERS

Removal, Installation

INITIAL SETUP

Personnel Required

Tools and Special Tools

Tool kit, general mechanic's (Item 112, WP 0185

Two

Equipment Condition

Shop equipment, general purpose repair (Item 97,

Right-front track carrier roller removed (WP 0114

Materials/Parts

Two frontmost track roller frame guards removed

Wood block, 4 in. x 4 in. x 12 in.

Lockwasher (2)

Crankcase and transmission guards opened (WP

References

TM 5-2410-233-10

Machine lifted off ground (WP 0178 00)

REMOVAL

WARNING

Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-

cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of

heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death.

NOTE

Equalizer bar weighs 300 lb (136 kg).

Remove two bolts (1), lockwashers (2), plates (3) and

pads (4) from equalizer bar (5). Discard lockwashers.

From rear of tractor, position hydraulic floor jack

under equalizer bar (5). Raise jack until it contacts

equalizer bar.

386-149