 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
EQUALIZER BAR ASSEMBLY REPLACEMENT - CONTINUED
0108 00
REMOVAL - CONTINUED
3.
Remove four bolts (6) and washers (7) from right sup-
6
port assembly (8) on right track roller frame.
9
7
4.
Use hydraulic floor jack to lift equalizer bar (5)
enough to remove right support (9).
5.
Carefully remove equalizer bar (5) by rotating bar and
pulling floor jack towards rear of tractor. Lower equal-
izer bar as soon as bar clears track roller frames.
6.
Use a suitable lifting device to remove equalizer bar
5
(5) from floor jack.
10
8
7.
If necessary, remove remaining right support assembly
(8) from right track roller frame as follows:
11
a.
Remove upper plate (10).
b.
Remove lower plate (11).
12
c.
Remove two pads (12).
13
d.
Remove lower suspension (13).
e.
Remove bar.
386-150
8.
If necessary, remove left front track carrier roller (WP
assembly.
9.
Repeat step 7, a through d, for left support assembly, if
necessary.
INSTALLATION
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death.
NOTE
Equalizer bar weighs 300 lb (136 kg).
1.
Install right support assembly (8) as follows:
a. Install bar.
b. Install lower suspension (13).
c. Install two pads (12).
d. Install lower plate (11).
e. Install upper plate (10).
2.
If removed, repeat step 1, a through e, for left support assembly (8).
3.
Install left support (9) with four washers (7) and bolts (6). Tighten bolts to 350 lb-ft (475 Nm).
4.
Use a suitable lifting device to place equalizer bar (5) on hydraulic floor jack.
0108 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals