EQUALIZER BAR ASSEMBLY REPLACEMENT - TM-5-2410-237-230701

TM 5-2410-237-23

EQUALIZER BAR ASSEMBLY REPLACEMENT

0133 00

THIS WORK PACKAGE COVERS

Removal, Installation

INITIAL SETUP

Tools and Special Tools

Personnel Required

Two

Tool kit, general mechanic's (Item 122, WP 0250

Equipment Condition

Shop equipment, general purpose repair (Item 106,

Right-front track carrier roller removed (WP 0137

Materials/Parts

Two frontmost track roller frame guards removed

Washer, lock (2 and 7)

Crankcase and transmission guards removed (WP

References

0157 00)

Tractor raised (WP 0243 00)

TM 5-2410-237-10

WARNING

Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-

cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of

heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to

personnel.

NOTE

Equalizer bar weighs 300 lb (136 kg).

REMOVAL

Remove four bolts (1), lockwashers (2), two plates (3)

and pads (4) from equalizer bar (5). Discard lockwash-

ers.

From rear of tractor, position hydraulic floor jack

under equalizer bar (5). Raise jack until it contacts

equalizer bar.

387-477