|
|
TM 5-2410-237-23
TRACK ASSEMBLY INSPECTION AND ADJUSTMENT - CONTINUED
0132 00
ADJUSTMENT - CONTINUED
10.
Start engine and move machine in reverse until rear face of idler bearing support (6) moves past mark made on track
roller frame (5).
11.
Move machine forward until pin (7) is free of sprocket (8). Shut down engine and remove pin.
12.
Connect grease gun to fill valve (3). Close relief valve (2).
13.
Pump grease into fill valve (3) until rear face of idler bearing support (6) lines up with mark made on track roller frame
(5).
14.
Close recoil mechanism access cover (1) and tighten bolt.
1
3
2
4
387-924
15.
Test drive and check track for proper operation.
END OF WORK PACKAGE
0132 00-8
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |