 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
EQUALIZER BAR ASSEMBLY REPLACEMENT - CONTINUED
0133 00
REMOVAL - CONTINUED
3.
Remove four bolts (6) and lockwashers (7) from right
support assembly (8) on right track roller frame. Dis-
card lockwashers.
4.
Use hydraulic floor jack to lift equalizer bar (5)
6
9
enough to remove right support (9).
7
5.
Carefully remove equalizer bar (5) by rotating bar and
pulling floor jack towards rear of tractor. Lower equal-
izer bar as soon as bar clears track roller frames.
6.
Use a suitable lifting device to remove equalizer bar
8
(5) from floor jack.
5
10
7.
If necessary, remove remaining right support assembly
(8) from right track roller frame as follows:
11
a.
Remove upper plate (10).
b.
Remove lower plate (11).
12
c.
Remove pad (12).
13
d.
Remove lower suspension (13).
8.
If necessary, remove left front track carrier roller (WP
assembly.
9.
Repeat step 7, a through d, for left support assembly, if
387-482
necessary.
INSTALLATION
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to
personnel.
NOTE
Equalizer bar weighs 300 lbs (136 kg).
0133 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals