TRANSMISSION AND CRANKCASE GUARDS REPLACEMENT

TM 5-2410-237-23

TRANSMISSION AND CRANKCASE GUARDS REPLACEMENT

0157 00

THIS WORK PACKAGE COVERS

Removal, Installation

INITIAL SETUP

Personnel Required

Tools and Special Tools

Tool kit, general mechanic's (Item 122, WP 0250

Two

Equipment Condition

Shop equipment, common no. 1 (Item 103, WP

Tractor parked on level ground (TM 5-2410-237-

Materials/Parts

10)

Compound, anti-seize (Item 6, WP 0249 00)

Engine OFF and cool (TM 5-2410-237-10)

Wood block, 2 in. x 4 in. x 18 in. long

WARNING

Use extreme caution when handling heavy parts. Provide adequate support and use assistance during

procedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep

clear of heavy parts supported only by lifting device. Failure to follow this warning may result in injury

or death to personnel.

Dirt and rocks under guards can significantly add to their weight.

NOTE

Transmission guard weighs 350 lb (159 kg).

Crankcase guard weighs 335 lb (152 kg).

REMOVAL

NOTE

An 18 in. (46 cm) piece of 2 x 4 wood block should be placed on jack to facilitate removal of transmission

and crankcase guards.

Apply light pressure to transmission guard (1) with hydraulic floor jack.

Remove six bolts (2) and washers (3).

Lower hydraulic floor jack and remove transmission

guard (1) from tractor.

Repeat step 2 for crankcase guard (4).

Remove eight bolts (5) and washers (6).

Lower hydraulic floor jack and remove crankcase

guard (4).

387-415