 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
WINCH ASSEMBLY REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Applicable Configuration
Materials/Parts - Continued
Gasket (3)
Tractor with winch
Lockwasher (2 and 12)
Tools and Special Tools
Personnel Required
Tool kit, general mechanic's (Item 112, WP 0185
Three
References
Shop equipment, common no. 2 (Item 95, WP 0185
TM 5-2410-233-10
TM 5-2410-233-23P
Link, lifting (Item 44, WP 0185 00)
Lifting equipment, 5,000 lb. capacity
Wood cribbing, 4 ft x 4 in. x 4 in.
Bolt, 3/4 x 10 -1-1/2 in.
Equipment Condition
Materials/Parts
Tractor parked on level ground (TM 5-2410-233-
Cap set, protective (Item 2, WP 0184 00)
10)
Oil, lubricating (Item 22, 23, 24 or 25, WP 0184 00)
Winch wire rope assembly removed, if required
Rag, wiping (Item 28, WP 0184 00)
Tag, marker (Item 35, WP 0184 00)
Winch oil drained (WP 0138 00)
NOTE
Tag hoses prior to removal to ensure proper installation.
Use a suitable container to catch any oil that may drain from system. Dispose of oil IAW local
policy and ordinances. Ensure all spills are cleaned up.
Use two wrenches when disconnecting and connecting hoses connections.
REMOVAL
1.
Clean external surfaces of winch to remove accumulated grease and dirt.
NOTE
Tractor will be immobilized when winch is removed. If tractor must be moved, perform step 2 to isolate
winch gear pump.
2.
Remove winch gear pump from rear of engine auxiliary drive (WP 0147 00). Cover opening where pump was removed
with plate that is listed and illustrated in TM 5-2410-233-23P.
3.
Disconnect linkage from winch control valve (WP 0142 00).
4.
Remove suction hose from oil filter assembly (WP 0143 00).
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals