 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-312-24-1
TRANSMISSION REPLACEMENT - CONTINUED
0139 00
INSTALLATION - CONTINUED
14
13
15
14
ENGINE BELL
HOUSING
ACCESS
COVER
15
12.
Remove transmission lift.
13.
Connect wiring harnesses and electrical leads to transmission and to transmission sensors and sending units (WP 0120
14.
Connect hydraulic hoses to fifth wheel lift hydraulic pump (WP 0161 00).
15.
Install transmission fill dipstick tube (WP 0027 00).
16.
Connect oil sampling valve hose to transmission (WP 0132 00).
17.
Connect transmission oil cooler hoses to transmission (WP 0029 00).
18.
Connect propshaft (Group 120 Commercial Service Manuals).
19.
Fill hydraulic system fluid (WP 0129 00).
20.
Fill transmission fluid (Group 070 Commercial Service Manuals).
21.
Ensure all fluid and air lines and electrical wiring are gathered into bundles and secured with new tiedown straps.
Ensure all removed clamps have been installed. Ensure all components are fully installed and properly supported.
22.
Connect battery cables (WP 0115 00).
23.
Lower cab (TM 9-2320-312-10).
24.
Start engine (TM 9-2320-312-10). Check for leaks.
25.
Recheck levels of transmission fluid, and hydraulic system fluid. Add as required.
26.
Install transmission access cover and rear platform grating (WP 0039 00).
NOTE
If a new transmission was installed, refer to Group 070 Commercial Service Manuals for information on
ECU programming.
END OF WORK PACKAGE
0139 00-9/10 Blank
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals