OIL SAMPLING VALVE REPLACEMENT

TM 9-2320-312-24-1

ENGINE AND TRANSMISSION OIL SAMPLING VALVES, HOSES,

AND FITTINGS REPLACEMENT - CONTINUED

0132 00

OIL SAMPLING VALVE REPLACEMENT

NOTE

Engine and transmission oil sampling valves are replaced the same way. Engine oil sampling valve is shown.

Remove oil sampling valve (1) from elbow (2).

Install oil sampling valve (1) to elbow (2). Ensure valve is positioned with discharge port (3) facing down.

ENGINE OIL SAMPLING VALVE HOSES AND FITTINGS REMOVAL

WARNING

When servicing this vehicle, performing maintenance, or disposing of materials such as engine coolant,

transmission fluid, lubricants, battery acids or batteries, consult your unit/local hazardous waste disposal

center or safety office for local regulatory guidance. If further information is needed, please contact The

Army Environmental Hotline at 1-800-872-3845.

NOTE

Use a drain pan to capture any residual oil in hoses. Dispose of oil in accordance with local policy and

ordinances. Ensure all spills are cleaned up.

Note routing of hoses to ensure correct installation.

Pipe sealing compound is used at certain fittings to ensure a leak-free seal. Note where pipe sealing

compound is used.

Tilt cab (TM 9-2320-312-10).

Disconnect hose (8) from straight fitting (7) at oil sampling valve (1).

As required, remove the following fittings at oil sampling valve (1):

0132 00-2