|
|
TM 5-2420-224-34
CAB
REPLACEMENT
(CONT)
4.
INSTALL SPACER (7), washer (8), and cab mounting screw (9) on each side of vehicle.
NOTE
Follow-on Maintenance (Cont):
Install rear windows (page 10-20)
Install front loader (SEE) or forklift
Install windshield (page 10-18).
(HMMH) control valve and bracket
Install main wiring harness (page
I n s t a l l Speedometer drive shaft
I n s t a l l auxiliary headlight, front
(TM 5-2420-224-20).
Install front loader (SEE) or forklift
composite light, and blackout
driving light wiring harness (page
( H M M H ) control valve controls
(TM 5-2420-224-20).
I n s t a l l chassis wiring harness
I n s t a l l data plates (TM 5-2420-
224-20).
Install cap plug connector to
Install heater hoses and clamps
h e a t e r panel switch and master
(TM 5-2420-224-20).
light switch wiring harness (page
I n s t a l l windshield washer pump
(TM 5-2420-224-20).
Install suppressor filter electrical
Install windshield washer reservoir
lead (page 4-66).
(TM 5-2420-224-20).
Install frame wiring harness (page
Install windshield wipers (TM 5-
4-58) .
2420-224-20).
I n s t a l l fuse holder to hydraulic
I n s t a l l cab floor linings (TM 5-
suspension lockout/rear wall wiring
2420-224-20.
harness (HMMH) (page 4-54).
Install cab door seals (TM 5-2420-
Install cab floor separation point to
224-20).
rear wall wiring harness (HMMH)
Install steering wheel bracket and
seal (TM 5-2420-224-20).
I n s t a l l forklift connector to fuse
Install brake master cylinder
h o l d e r wiring harness (HMMH)
hydraulic lines and fittings (TM 5-
2420-224-20).
Install forklift wiring harness
Install protection/relay valve
(HMMH) (page 4-42).
(TM 5-2420-224-20).
Install hazard warning light wiring
Install brake light switch (TM 5-
harness (page 4-36).
2420-224-20).
Install dome light cable assembly
Install engine start switch (TM 5-
2420-224-20).
Install alternator cable assembly
I n s t a l l turn signal flasher relay
(TM 5-2420-224-20).
10-15
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |