Chapter 2 SERVICES AND SCHEDULED VEHICLE MAINTENANCE

TM 5-2420-224-20-1

CHAPTER 2

SERVICES AND SCHEDULED VEHICLE MAINTENANCE

SCOPE

This chapter contains information you will need to prepare the SEE/HMMMH for daily use

and to perform preventive and scheduled maintenance. The following sections are included in

this chapter.

Page

Section I

Repair Parts; Special Tools; Test, Measurement, and

Diagnostic Equipment (TMDE); and Support Equipment .......................................

2-1

Section II

Service Upon Receipt .............................................................................................

2-2

Section III

Preventive Maintenance Checks and Services ......................................................

2-2

Section IV

Lubrication Instructions ...........................................................................................

2-14

Section V

Painting and Restenciling Markings .......................................................................

2-14.24

Section VI

General Repair and Cleaning Methods ..................................................................

2-15

Section VII

General Hydraulic System Repair Methods ...........................................................

2-32

Section VIII

Preparation for Storage or Shipment ......................................................................

2-36

Section I. REPAIR PARTS; SPECIAL TOOLS; TEST, MEASUREMENT, AND

DIAGNOSTIC EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT

OVERVIEW

This section includes information on tools and equipment you need to support the SEE and

HMMH tractors.

COMMON TOOLS AND EQUIPMENT

For authorized common tools and equipment, refer to the Modified Table of Organization

and Equipment (MTOE) applicable to your unit. Tool kits required for each task in this manual

are listed in the Maintenance Allocation Chart (MAC) in Appendix B and on the INITIAL SETUP

page of each task.

SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT

Special tools and support equipment required to maintain the SEE/HMMH are listed in the

Maintenance Allocation Chart (MAC) Appendix B and on the INITIAL SETUP page of each task.

Special tools are also listed in the Repair Parts and Special Tools List (TM 5-2420-224-24P).

Tools that are to be fabricated are described and listed in Appendix D of this manual.

REPAIR PARTS

Repair parts are listed and illustrated in the Repair Parts and Special Tools List

(TM 5-2420-224-24P) covering the unit maintenance of this equipment.

Change 2

2-1