General Repair Methods

TM 5-2420-224-20-1

5. Remove pin and clevis assemblies (4) and tow bar (3) from two clamps (5).

6. Remove two clamps (5) from crossbar (6) of forklift (7).

7. Close shutoff valve (TM 5-2420-224-10).

Section

VII.

GENERAL

HYDRAULIC

SYSTEM

REPAIR

METHODS

This section contains repair methods for the hydraulic system. If special repair methods or

procedures are required for the hydraulic system or related parts, these methods or procedures are

included in the individual maintenance procedures in Chapter 4.

WARNING

High pressure hydraulics [oil under 2450 psi (16,893 kPa)] operate this

equipment. Never disconnect any hydraulic line or fitting without first dropping

pressure to zero. A high pressure oil stream can pierce body and cause

s e v e r e injury to personnel.

CAUTION

Always clean around fittings before disconnecting or connecting hose of

fittings. Make sure area is clean before installing hydraulic components.

F a i l u r e to do so could result in damage to equipment.

Cover, cap, or plug all openings, ports, and tube or hose ends when

d i s c o n n e c t e d . Failure to do so could result in damage to equipment.

Change 2