RIPPER SHANK REPLACEMENT - TM-5-2410-237-231271

TM 5-2410-237-23

RIPPER SHANK REPLACEMENT

0240 00

THIS WORK PACKAGE COVERS

Removal, Installation

INITIAL SETUP

Materials/Parts

Applicable Configuration

Blocks, 8 in. x 8 in. x 5 ft long

Tractor with ripper

Pin, cotter (5)

Tools and Special Tools

References

Tool kit, general mechanic's (Item 122, WP 0250

Shop equipment, common no. 1 (Item 103, WP

Personnel Required

0250 00)

Three

Lifting equipment, 1,000 lb capacity

Equipment Condition

Machine parked on level ground (TM 5-2410-237-

10)

Use extreme caution when handling heavy

parts. Provide adequate support and use

assistance during procedure. Ensure that

any lifting device used is in good condition

and of suitable load capacity. Keep clear

of heavy parts supported only by lifting

device. Failure to follow this warning may

result in death or injury to personnel.

REMOVAL

Raise ripper (1) to its maximum raised position.

Place suitable block(s) under beam (2) and shut down

engine.

Attach a nylon sling and a suitable lifting device to

shank (3). Remove slack in lifting device.

387-386