|
|
TM 5-2410-237-23
RIPPER TOOTH REPLACEMENT - CONTINUED
0239 00
INSTALLATION
1.
Install retainer (5) in recess on R.H. side of shank (6).
NOTE
Ripper tooth weighs 24 lb (11 kg).
2.
Slide tooth (2) over end of shank (6) and retainer (5). Insert pin (4) in tooth and shank, grooved end first.
3.
From L.H. side of tooth (2), drive pin (4) through retainer (5) until flush on both sides of tooth.
1
3
4
6
2
5
2
387-385
4.
Repeat steps 1-3 for other two teeth.
5.
Start engine, raise ripper, remove blocks, lower ripper and turn off engine (TM 5-2410-237-10).
END OF WORK PACKAGE
0239 00-2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |