 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
RIPPER TOOTH REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Materials/Parts
Applicable Configuration
Blocks, 4 in. x 4 in.
Tractor with ripper
Equipment Condition
Tools and Special Tools
Machine parked on level ground (TM 5-2410-237-
Tool kit, general mechanic's (Item 122, WP 0250
10)
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Failure to follow this warning may result in injury or death to personnel.
REMOVAL
1.
Raise ripper assembly (1) until teeth (2) are approximately 6 in. (15.2 cm) off ground.
2.
Place blocks under ripper beam (3). Shut down engine.
NOTE
Ripper tooth weighs 24 lb (11 kg).
3.
While facing rear of tractor, drive pin (4) from R.H. side of tooth (2).
4.
Remove tooth (2) and retainer (5) from shank (6).
5.
Repeat steps 3 and 4 for other two teeth.
1
3
4
6
2
5
2
387-385
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals