 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
TORQUE DIVIDER REPLACEMENT - CONTINUED
0092 00
INSTALLATION - CONTINUED
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during
procedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear
of heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury
to personnel.
NOTE
Torque divider weighs 300 lb (136 kg).
6.
Fasten a nylon sling and a suitable lifting device to two lifting links (1) and carefully lift torque divider (2) into position.
7.
Slide torque divider (2) onto studs on flywheel housing (6). Remove wire.
NOTE
Carefully maneuver torque divider onto flywheel housing so that planetary gears engage with flywheel.
8.
Install 12 new lockwashers (4) and nuts (3). Tighten nuts to 75 lb-ft (102 Nm).
9.
Remove lifting equipment, two bolts, and lifting links (1) from top of torque divider (2).
10.
Install torque divider scavenge pump (WP 0097 00).
11.
Install torque converter outlet relief valve (WP 0096
2
6
A
12.
Connect transmission oil lines to torque divider (WP
13.
Connect transmission oil cooler lines to torque divider
14.
Connect brake lock linkage (WP 0124 00).
15.
Connect steering clutch linkage (WP 0123 00).
1
16.
Install driveshaft (WP 0106 00).
17.
Install brake pedal assembly (WP 0121 00).
18.
Install seat and seat base assembly (WP 0137 00).
19.
Install dash assembly.
20.
Install floor plates (WP 0135 00).
21.
Install ROPS (WP 0131 00).
22.
Install transmission guard (WP 0129 00).
23.
Refill torque divider and transmission (WP 0086 00).
386-827
3
4
5
A
24.
Run engine and test drive in all speeds (TM 5-2410-
233-10).
END OF WORK PACKAGE
0092 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals