 |
|||
|
|
|||
|
Page Title:
Unit Injector Hydraulic Pump - Install |
|
||
| ||||||||||
|
|
 TM 9-2320-312-24-2
Truck Engine
Disassembly and Assembly Section
5. Remove return line (6) from the engine block
i01335912
and fitting (5).
Unit Injector Hydraulic Pump
- Install
SMCS Code: 1714-012
Installation Procedure
Table 11
Required Tools
Part
Tool
Part Description
Qty
Number
1
5P-0327
Crowfoot Wrench
A
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
g00706976
Illustration 46
6. Cut nylon strap (9) that fastens the wiring
harness to unit injector hydraulic pump (8).
7. Remove three bolts (10) and remove unit injector
hydraulic pump (8) from the timing gear housing.
g00706978
Illustration 48
1. Position drive gear (14) on the unit injector
hydraulic pump. Install bolt (12) and washer (13)
on the unit injector hydraulic pump. Tighten bolt
(12) to a torque of 110 14 Nm (81 10 lb ft).
2. Lubricate O-ring seal (11) with clean engine
g00706978
Illustration 47
oil. Install the O-ring seal on the unit injector
hydraulic pump.
8. Remove O-ring seal (11) from unit injector
hydraulic pump (8). Inspect the O-ring seal for
wear or damage. If the O-ring seal is worn or
damaged, use a new part for replacement.
9. Remove bolt (12) and washer (13). Remove drive
gear (14). Inspect the drive gear for wear or
damage. Replacethe drive gear, if necessary.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals