Cylinder Block -807640054

TM 9-2320-312-24-2

Specifications Section

(4) The dowels extend past the front face of the

(7) Sleeve (3) extends from the face of cylinder

cylinder block. Distance .............. 8.0 0.5 mm

block (1). Distance ....................... 5.0 0.5 mm

(.31 .02 inch)

(0.20 0.02 inch)

g00945479

g00292820

Illustration 31

Illustration 33

Bolt tightening sequence for side cover (typical example)

View A-A

(8) Tighten bolts (1 through 8) in a numerical

(5) Bore diameters in the cylinder block for

sequence.

all camshaft bearings except the front

bearing ............................... 69.000 0.038 mm

Tighten the bolts to the following

(2.7165 .0015 inch)

torque. .............................. 28 7 Nm (21 5 lb ft)

(6) Locate the bearing oil hole for all camshaft

bearings at the top of the bore. The front

i01574825

camshaft bearing is not located at the top of

Cylinder Block

the bore.

SMCS Code: 1201

g00292819

Illustration 32

(1) The installation depth of the cup plug is

measured from the block face to the top edge

of the plug. Distance ................ 1.25 0.25 mm

(.049 .010 inch)

(2) The dowels extend past the top face of the

cylinder block. Distance .................. 14 2 mm

(.55 .080 inch)

g00292821

Illustration 34

(3) The two large dowels extend past the rear face

of the cylinder block. Distance .. 12.0 0.5 mm

(.47 .02 inch)