PLACING CAB IN 90-DEGREE TILT POSITION

TM 9-2320-312-24-1

PLACING CAB IN 90-DEGREE TILT POSITION

0147 00

THIS WORK PACKAGE COVERS

Placing Cab in 90-Degree Tilt Position, Returning Cab to 45-Degree Tilt Position

INITIAL SETUP

Materials/Parts

Maintenance Level

Direct Support

Strap, tiedown (Item 57, WP 0165 00)

RPSTL Reference

Nut, lock (P/N 21NE048)

Group 020, Figure 2

Pin, cotter (P/N 60-78) (2)

Group 110, Figure 1

Washer, lock (P/N 361-11)

Group 140, Figure 1

Group 170, Figures 10 and 16

References

Group 190, Figure 2

TM 9-2320-312-10

Tools and Special Tools

Personnel Required

Tool kit, general mechanic's (Item 35, WP 0166 00)

Shop equipment, field maintenance (Item 27, WP

Two

Equipment Condition

Overhead lift with braking device (3-ton capacity)

Lifting chains, 3/8 in, Grade 30 or equivalent

Vehicle positioned on level surface under overhead

lift

Two clevises

Wheels blocked

Wood cribbing, 6 in (15.2 cm)

WARNING

DO NOT work under cab unless cab is properly supported. Cab could fall and cause serious injury to

personnel.

Always check that cab tilt safety prop is properly engaged before working under cab. Cab could fall and

cause serious injury or death.

Use extreme caution when handling heavy parts. Provide adequate support and use assistance during

procedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep

clear of heavy parts supported only by lifting device. Failure to follow this warning may result in injury

or death to personnel.