 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-312-24-1
TRANSMISSION REPLACEMENT - CONTINUED
0139 00
INSTALLATION - CONTINUED
b.
Install transmission mounting bracket (1) to transmission (11) with four bolts (17). Tighten bolts to 66-81 lb-ft
(90-110 Nm).
17
1
11
c.
Install anchor bracket for wiring harness connector to right rear of transmission with bolt and nut.
d.
Install rear yoke (Group 070 Commercial Service Manuals).
e.
Install fifth wheel lift hydraulic pump (WP 0161 00).
f.
Install PTO and PTO hose to transmission (Group 070 Commercial Service Manuals).
g.
Install transmission sensors and sending units (Group 070 Commercial Service Manuals).
h.
Install transmission oil sampling valve hose fittings (WP 0132 00).
i.
Install transmission oil cooler fittings (WP 0029 00).
j.
Install all other hoses, lines, and fittings that must be transferred to new transmission.
k.
Remove torque converter shipping restraint bar from torque converter bell housing. Transfer restraint bar to
old transmission.
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during
procedure. Ensure that any lifting device used is in good condition and of suitable capacity. Keep clear
of heavy parts supported only by lifting device. Failure to follow this warning may result in injury or
death to personnel.
2.
If torque converter was removed, insert torque converter on input shaft inside transmission bell housing. Push in
and rotate until seated.
0139 00-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals