 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-312-24-1
TRANSMISSION REPLACEMENT - CONTINUED
0139 00
REMOVAL - CONTINUED
NOTE
If a new engine or transmission is being installed, thoroughly inspect old engine or transmission and
compare to the new engine or transmission. Ensure all components on old engine or transmission that
need to be transferred to the new have been identified and are removed.
11.
If replacing transmission with a new transmission, perform the following steps:
a.
Remove four bolts (17) and transmission mounting bracket (1) from transmission (11).
17
1
11
b.
Remove rear yoke (Group 070 Commercial Service Manuals).
c.
Remove nut, bolt, and wiring harness connector anchor bracket from right rear of transmission.
CAUTION
Wipe area clean around all hydraulic connections prior to disconnecting. Cap or plug all openings after
disconnecting. Contamination of hydraulic system could result in equipment failure.
d.
Remove fifth wheel lift hydraulic pump (WP 0161 00).
e.
Remove PTO and PTO hose from transmission (Group 070 Commercial Service Manuals).
f.
Remove transmission sensors and sending units (Group 070 Commercial Service Manuals).
g.
Remove transmission oil sampling valve hose fittings (WP 0132 00).
h.
Remove transmission oil cooler fittings (WP 0029 00).
i.
Remove all other hoses, lines, and fittings that must be transferred to new transmission.
INSTALLATION
1.
If installing new transmission, perform the following steps:
a.
Remove all shipping plugs and PTO cover plate and transfer them to old transmission to seal old transmission
for storage or shipment.
0139 00-5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals