 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-312-24-1
POWERPACK REPLACEMENT - CONTINUED
0138 00
INSTALLATION - CONTINUED
39.
Install radiator assembly, fan shroud, and charge air cooler (WP 0142 00).
40.
Install AC receiver-drier to radiator (WP 0154 00).
41.
Install upper and lower engine-to-radiator hoses (WP 0025 00).
42.
Install radiator air recirculation bottom shield (WP 0026 00).
43.
Install exhaust tubing between turbocharger and muffler (WP 0022 00).
44.
Install engine charge air cooling hoses and tubes (WP 0016 00).
45.
Install air intake tubes (WP 0015 00).
46.
Ensure all fluid and air lines and electrical wiring are gathered into bundles and secured with new tiedown straps.
Ensure all removed clamps have been installed. Ensure all components are fully installed and properly supported.
47.
Fill hydraulic system oil reservoir (WP 0129 00).
48.
Fill engine oil (WP 0011 00).
49.
Fill transmission fluid (Group 070 Commercial Service Manuals).
50.
Fill cooling system (WP 0023 00).
51.
Connect battery cables (WP 0115 00).
52.
Return cab to 45-degree tilt position (WP 0147 00).
53.
Lower cab (TM 9-2320-312-10).
54.
Start engine (TM 9-2320-312-10). Check for leaks.
55.
Recheck levels of engine oil, transmission fluid, engine coolant, and hydraulic system fluid. Add as required.
56.
Install transmission access cover and rear platform grating (WP 0039 00).
57.
Remove wheel blocks.
NOTE
If a new engine or transmission was installed, refer to Group 020 or Group 070 Commercial Service
Manuals for information on ECU programming.
END OF WORK PACKAGE
0138 00-20
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals