 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2420-224-34
FRONT AXLE ASSEMBLY REPLACEMENT (CONT)
5.
INSTALL FRONT
BRAKE
(TM 5-2420-224-20).
6.
INSTALL FRONT AXLE THRUST TUBE
7.
INSTALL FRONT
PROPELLER
SHAFT
8.
POSITION upper housing HALF (1) and
HOUSING (1.1) on axle thrust tube (2).
9.
WITH VEHICLE on suitable jack STANDS,
RAISE VEHICLE and place front axle
assembly (3) in position.
WARNING
Place a suitable support under
torque tube and one wheel.
Failure to do so could result in
injury to personnel.
CAUTION
Make sure slots are aligned in
shaft and transmission during
installation to prevent damage to
equipment.
10. APPLY COAT of MOLYBDENUM DISULFIDE
GREASE to propeller shaft FLANGE (4) and
ALINE propeller shaft FLANGE (4) with
"
transmission output flange (5).
11. APPLY COAT of SEALING COMPOUND to
six SCREWS (6) and INSTALL. TIGHTEN
SCREWS to 42 lb-ft (56 N.m).
12. INSTALL lower housing half (7), four new
&
lock washers (8), and four nuts (9). HAND
'
TIGHTEN.
13. APPLY COAT of SEALING COMPOUND to
four SCREWS (10) and INSTALL four
SCREWS (10) and four new SEAL RINGS
(11). TIGHTEN SCREWS to 45 lb-ft (60 N.m).
TIGHTEN NUTS (9) to 45 lb-ft (60 N.m).
!
%
14. SLIDE BELLOWS (12) up and INSTALL two
CLAMPS (13). TIGHTEN CLAMPS.
15. INSTALL vent HOSE (14) on bellows (12).
Change 1
5-9
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals