BLADE TILT CYLINDER REPLACEMENT - TM-5-2410-237-231085

TM 5-2410-237-23

BLADE TILT CYLINDER REPLACEMENT

0209 00

THIS WORK PACKAGE COVERS

Removal, Installation, Adjustment

INITIAL SETUP

Tools and Special Tools

Materials/Parts - Continued

Tag, marker (Item 37, WP 0249 00)

Tool kit, general mechanic's (Item 122, WP 0250

Lockwasher (2)

O-ring (9)

Shop equipment, common no. 1 (Item 103, WP

Pin, cotter (14)

Sling, nylon (Item 109, WP 0250 00)

References

WP 0226 00

Lifting equipment, 1,000 lb capacity (minimum)

Personnel Required

Materials/Parts

Three

Cap set, protective (Item 2, WP 0249 00)

Equipment Condition

Grease, GAA (Item 16, WP 0249 00)

Machine parked on level ground (TM 5-2410-237-

Oil, lubricating (Item 23, 24 or 25 WP 0249 00)

10)

Rag, wiping (Item 29, WP 0249 00)

Hydraulic system pressure relieved (WP 0241 00)

WARNING

Do NOT remove hydraulic tank filler cap, disconnect or remove any hydraulic system line or fitting unless

hydraulic system pressure has been relieved. Hydraulic system pressure can be over 2500 psi (17,237 kPa),

even with engine and pump OFF. To relieve pressure, lower all hydraulic attachments to the ground and

shut down engine. Move control levers through all operating positions, then SLOWLY loosen hydraulic

tank filler cap. After maintenance, tighten all connections before applying pressure. Escaping hydraulic

fluid under pressure can penetrate the skin causing serious injury or death.

REMOVAL

CAUTION

Wipe area clean around all hydraulic connections to be opened during removal. Cap lines and plug open-

ings after removing hydraulic lines. Contamination of hydraulic system could result in premature failure.

NOTE

Tag hydraulic hoses to ensure correct installation.

Use a suitable container to catch any hydraulic oil that may drain from hoses or system. Dispose of oil

IAW local policy and ordinances. Ensure all spills are cleaned up.