TRACK ASSEMBLY REPLACEMENT - TM-5-2410-237-230755

TM 5-2410-237-23

TRACK ASSEMBLY REPLACEMENT

0143 00

THIS WORK PACKAGE COVERS

Removal, Installation

INITIAL SETUP

Tools and Special Tools

Materials/Parts

Compound, antiseize (Item 6, WP 0249 00)

Tool kit, general mechanic's (Item 122, WP 0250

References

Shop equipment, common no. 1 (Item 103, WP

Personnel Required

Tool set, track repair (Item 125, WP 0250 00)

Two

Drawbar pin (TM 5-2410-237-10)

Lifting equipment, 4,000 lb capacity

Equipment Condition

Machine parked on level ground

Wood block, 4 in. x 4 in. x 8 in.

REMOVAL

Remove all dirt and debris that may prevent retraction of the idler.

WARNING

Adjuster cylinder for track is under high pressure. Use the following procedure to relieve this pressure

and observe relaxing of tension on track.

Wear eye protection and use extreme caution. Do NOT observe grease coming from relief valve.

Do NOT, under any circumstances, attempt to relieve pressure by excessive loosening or removal of

relief valve (3). Failure to follow these precautions could result in serious personal injury.

Loosen bolt (1) and open track adjuster access panel (2).

Turn relief valve (3) one turn counterclockwise to

release grease from vent hole below relief valve.

387-594