Figure 7-17. Preparing to remove guide plate.

Bolts

Collar

Bolts

1 Guard

Bearing

2 Bolts

Yoke

3 Guide plate

Figure 7-17. Preparing to remove guide plate.

Figure 7-18. Preparing to remove idler.

(3) Remove bolts (1, fig. 7-18) securing collar

b. Disassembly.

(2) to bearing (4) and yoke (5) and remove shims

(1) Remove the nuts and washers and drive

from between the bearing and the collar. Install one

out the tapered pins that secure bearings (1. fig. 7-

of the bolts (1) through the collar into bearing (4)

19) and (4) to shaft (5).

to hold the collar in place.

(2) Remove bearings (1 and 4) from shaft (5).

(4) Remove bolts (3) securing bearing (4) to

(3) Remove floating duo-cone seals (2) from

yoke (5). Support the idler and roll it forward.

the bearings and from the bushing assemblies (6).