Figure 6-82. Preparing to remove steering clutch assembly.

Figure 6-83. Removing steering clutch assembly.

Figure 6-82. Preparing to remove steering clutch assembly.

(5) Before

installing the steering clutch

a s s e m b l y , inspect

the splines of the outer drum and

(3) Attach a suitable hoist and sling to the

t h e teeth of the

discs for roughness and excessive

b r a k e band and pry the outer drum away from the

wear. Replace if

not reusable.

flange.

(4) Remove the two bolts securing the inner

NOTE

d r u m to the hub, pry the drum away from the hub,

The following procedure will permit the flange on the

pinion shaft and the steering clutch outer drum to

a n d remove the steering clutch assembly as shown

draw together without binding at the time of in-

stallation.

CAUTION

(6) Install one bolt that secures the outer drum

Keep the steering clutch assembly level

t o the flange, but do not tighten the bolt too tight.

since the clutch is free to slide out of the

( 7 ) Rotate the steering clutch 180 by moving

outer drum.

the machine or the sprocket.