BLADE CONTROL LEVER AND LINKAGES REPLACEMENT

TM 5-2410-233-23

BLADE CONTROL LEVER AND LINKAGES REPLACEMENT

0152 00

THIS WORK PACKAGE COVERS

Removal, Cleaning and Inspection, Installation, Adjustment

INITIAL SETUP

References

Tools and Special Tools

TM 5-2410-233-10

Tool kit, general mechanic's (Item 112, WP 0185

TM 5-2410-233-23P

Materials/Parts

Cleaning compound, solvent (Item 4, WP 0184 00)

Equipment Condition

Rag, wiping (Item 28 WP 0184 00)

Hydraulic system pressure relieved (WP 0176 00)

Floor plates removed (WP 0135 00)

Lockwasher (2)

WARNING

Do NOT remove hydraulic tank filler cap or disconnect or remove any hydraulic system line or fitting

unless hydraulic system pressure has been relieved. Hydraulic system pressure can be over 2500 psi (17,237

kPa), even with engine and pump OFF. To relieve pressure, lower all hydraulic attachments to the ground

and shut down engine. Move control levers through all operating positions, then SLOWLY loosen hydraulic

tank filler cap. After maintenance, tighten all connections before applying pressure. Escaping hydraulic oil

under pressure can penetrate the skin, causing serious injury or death.