 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
TRANSMISSION AND CRANKCASE GUARDS REPLACEMENT - CONTINUED
0129 00
TRANSMISSION GUARD REMOVAL
1.
Raise bulldozer blade, install hydraulic jack stands under blade and lower blade onto jack stands (WP 0178 00). Shut
down engine.
NOTE
An 18 in. piece of 2 x 4 wood block should be placed on jack to facilitate transmission guard removal.
2.
Apply light pressure to transmission guard (1) with
4
hydraulic floor jack.
5
6
1
7
NOTE
Transmission guard is equipped with a hinge
for ease of access to tractor components.
3.
Remove six capscrews (2) and lockwashers (3) and
lower hydraulic floor jack and transmission guard (1).
Discard lockwashers.
3
2
386-519
NOTE
If complete removal of transmission guard is required, continue with step 4 and 5.
4.
Remove capscrew (4), lockwasher (5), lock plate (6) and retaining clip (7). Discard lockwasher and retaining clip.
5.
Lower hydraulic floor jack and remove transmission guard (1) from tractor.
TRANSMISSION GUARD INSTALLATION
NOTE
An 18 in. piece of 2 x 4 wood block should be placed on jack to facilitate transmission guard installation.
1.
Place transmission guard (1) on hydraulic floor jack and raise into position.
2.
Position hinge of transmission guard (1) and align holes.
3.
Apply enough pressure on jack to hold transmission guard (1) in position.
NOTE
Apply antiseize compound to threads of mounting capscrews.
4.
Install capscrew (4), new lockwasher (5) lock plate (6) and new retaining clip (7).
NOTE
Do not tighten capscrews on transmission guard until all capscrews have been installed.
5.
Install six new lockwashers (3) and capscrews (2). Tighten capscrews.
6.
Raise bulldozer blade and remove hydraulic jack stands from blade (WP 0178 00). Lower blade.
0129 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals