 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
TRACK ASSEMBLY REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
References
Tools and Special Tools
Tool kit, general mechanic's (Item 112, WP 0185
Personnel Required
Shop equipment, common no. 1 (Item 94, WP 0185
Two
Tool set, track repair (Item 114, WP 0185 00)
Equipment Condition
Lifting equipment, 500 lb capacity
Machine parked on level ground (TM 5-2410-233-
10)
Pin, drawbar (TM 5-2410-233-10, BII Item 5)
Materials/Parts
Block, Wood 2-1/4 in.
Compound, antiseize (Item 6, WP 0184 00)
REMOVAL
1.
Remove all dirt and debris that may prevent retraction of the idler.
2.
Loosen bolt (1) and open track adjuster access panel (2).
Adjuster cylinder for track is under high pressure. Use the following procedure to relieve this pressure
and observe relaxing of tension on track.
Wear eye protection and use extreme caution. Do NOT observe grease coming from relief valve.
Do NOT, under any circumstances, attempt to relieve pressure by excessive loosening or removal of
relief valve. Failure to follow this warning may result in injury or death to personnel.
3.
Turn relief valve (3) one turn counterclockwise to
1
release grease from vent hole below relief valve.
3
2
386-250
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals