Click here to make tpub.com your Home Page

Page Title: Table 2. Transmission Troubleshooting Procedures.
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 5-2410-233-23
TROUBLESHOOTING PROCEDURES - CONTINUED
0006 00
Table 2. Transmission Troubleshooting Procedures.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1. No Response to Transmission Selector Lever 1. Check transmission oil level.
Add oil as required (WP 0086
Movement.
2. Check transmission control Adjust  transmission
control
linkage
for
correct linkage (WP 0083 00).
adjustment.
3. Check for air leaks at inlet Tighten connection or replace
side of transmission oil pump. damaged elbow and seal (WP
Incorrect Response to Transmission Selector 1. Check transmission oil level.
Add oil as required (WP 0086
2.
Lever Movement.
2. Check transmission control Adjust  transmission
control
linkage
for
correct linkage (WP 0083 00).
adjustment.
1. Check transmission oil level.
Add oil as required (WP 0086
3.
Excessive Noise During Shifting.
2. Inspect  drive  shaft  and Tighten or replace damaged
universal joint bearings for components (WP 0106 00).
looseness, wear and damage.
Transmission Downshifts During Operation Check for loss of transmission oil Add oil as required (WP 0086
4.
Lever pressure caused by low fluid 00).
(No
Transmission
Selector
level.
Movement).
1. Check transmission oil level.
1. If overfill condition exists,
5.
Transmission Overheats.
drain oil to proper level (WP
2. If low level is indicated, add oil
as required (WP 0086 00).
2. Check oil cooler and lines for Replace  oil  cooler  and/or
damage.
damaged lines (WP 0087 00 and
transmission Replace transmission oil pump if
3. Perform
lubricating oil pressure test pressures are not within required
4. Possible clutch discs and Replace transmission assembly
plates damage.
1. Check transmission oil level.
Add oil if necessary (WP 0086
6.
Low Transmission Oil Pressure.
2. Check for damaged oil lines.
Replace damaged oil line(s) (WP
3. Perform  transmission  oil Replace transmission oil pump if
pump pressure tests (WP pressures are still not within
required limits (WP 0095 00).

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business