Figure 4-30. Current regulator test setup.

5. If current regulator is not within limits, obtain proper amperage.

bend lower armature spring anchor (fig. 4-27) to

Figure 4-30. Current regulator test setup.

( 3 ) Disconnect storage battery lead from

4-48. Starting Motor

starter.

test on

a. Testing.

(4) Disconnect and tag two leads from starter

starting motor as follows:

to starter relay.

(1) Assure that battery is fully charged.

(5) Remove screw, nut and washers securing

(2) With ignition switch in OFF position, press

starter to transmission case and remove starter.

starter button and hold for a few seconds.

c. installation. Reverse procedure in b a b o v e .

(3) While engine is cranking, listen for any

unusual noises.

4-49. Distributor

a. Removal.

Note. If starting motor fails to crank engine, if

(1) Loosen nut and washers at distributor

operation is sluggish, or if unusual noises are evident, replace,

starting motor.

primary terminal (fig. 4-31) and remove primary

b. Removal.

circuit lead-in wire.

(1) Open battery compartment door and

(2) Snap spring clips from distributor cap and

disconnect positive s t o r a g e battery lead from

lift cap from distributor. Do not remove wires from

storage battery.

cap.

(2) Block up vehicle to a suitable working

height.