Modification Procedures. (Cont) - MWO-5-2410-236-20-10005

MWO 5-2410-236-20-1

10. Modification Procedures - (Continued).

b. INSTALL NEW WIRE ROPE ASSEMBLY.

NOTE

Installation of a wire rope on a plain (smooth) face drum requires a great deal

of care. Close supervision should be maintained throughout installation.

1. Refer to Figure 1.

2. Attach the new cable assembly to the drum (6) by placing the ferrule (4) into the ferrule slot (5) on the

drum (6).

3. To secure the ferrule (4) in the ferrule slot (5) install the clamp (3), lockwasher (2), and screw (1)

and tighten to 110-132 lb-ft (149-179 N.m).

CAUTION

The first layer of rope on the drum must be tight and without

spaces to insure succeeding layers will go on properly.

4. Maintain tension on the cable (2) as it is being unspooled from the spool (3) and wind onto the drum (1).

Each turn is to be guided as close to the preceding turn as possible, so there are not gaps between turns. To

produce smooth layers start the rope against the flange of the drum and keep tension on the line while

unspooling from the spool. (Refer to Figure 2).

5. Continue to wind all cable (2) onto drum (1)

Figure 2.