Modification Procedures.

MWO 5-2410-236-20-1

8. MWO Kit(s) and Their Disposition - (Continued).

c. BULK AND EXPENDABLE MATERIAL. Not applicable.

d. PARTS DISPOSITION. Dispose of excess or obsolete parts listed in table 5 in accordance with

DA PAM 710-2 or as directed by local authority.

Table 5. Excess and Obsolete Parts

CAGE

Part No.

NSN

Nomenclature

Qty

11083

3R8990

Wire Rope Assembly

9. Special tools, tool kits, jigs, fixtures, and Test, Measurement, and Diagonstic Equipment (TMDE)

required. Not applicable.

10. Modification Procedures.

WARNING

Thick gloves should be worn when working with cable. Failure

to do so may cause severe injury to hands and fingers.

a. REMOVE OLD WIRE ROPE ASSEMBLY.

NOTE

Wire rope assembly may not be present on all tractors. It's removal

has been previously directed through a Safety of Use Message.

1. Refer to Figure 1.

2. Reel out cable from winch by slowly engaging and disengaging clutch. See TM 5-2410-236-10.

3. Remove screw (1), lock washer (2), and clamp (3).

4. Remove ferrule (4) from ferrule slot (5) on winch drum (6). Set wire rope assembly aside for

disposition per paragraph 8.

Figure 1.