Click here to make tpub.com your Home Page

Page Title: ELECTRONIC FOOT PEDAL ASM (EFPA) CIRCUIT FAILED HIGH (VOLTAGE HIGH) ALSO CALLED THROTTLE POSITION SENSOR (TPS)
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 9-2320-364-20-1
2-14. DDEC III/IV TROUBLESHOOTING (CONT).
Section IV. TROUBLESHOOTING CHARTS (Cont.)
E. FLASH CODE:
21
J1587 CODE:
P91 3 -
ELECTRONIC FOOT PEDAL ASM (EFPA) CIRCUIT FAILED HIGH
(VOLTAGE HIGH) ALSO CALLED THROTTLE POSITION SENSOR
(TPS)
NOTE - This chart is only to be used if:
-
1) All basic mechanical checks and physical inspections have been performed with no problem found; and,
2) Diagnosis of DDEC III/IV was started at step START-1, pg 2-539, and you have now been referred here.
NOTE - Checks at the TPS connector must be made at MC6, not at the connector on the electronic throttle.
-
STEP/SEQUENCE
RESULT
WHAT TO DO NEXT
21-1
Multiple Code Check
Were there any other active
No other active codes.
Go to 21-2.
codes besides 91/3?
Yes, any or all
Go to VEH5V-1 (page 2-767).
of the following active
codes: 187/3, 91/4.
Yes - But none
Go to 21-2.
of the above.
21-2
Sensor Check
Turn ignition off.
Any code
Go to 21-3.
Disconnect TPS connector.
(except Code 91/3).
Turn ignition on.
Read active codes.
Code 91/3 (and any
Go to 21-7.
other codes).
21-3
Return Circuit
Check
Turn ignition off.
Less than or
Go to 21-4.
Install a jumper wire between pins
equal to 5 ohms.
B and C of the TPS harness
connector.
Greater than
Return line (ckt #952) and/or
Disconnect the vehicle harness
5 ohms open.
signal (ckt #417) is open.
connector at the ECM.
Repair open. Then go to 21-30.
Read resistance between sockets
D2 and C3 on the vehicle harness
connector.
21-4
Check TPS
Adjustment
Reconnect vehicle harness
Getting 64-205
Go to 21-6.
connector and plug TPS back in.
counts at no throttle and
Hook-up DDR to the DDL
less than 968 counts at
connector and select TPS CNTS.
full throttle.
Turn ignition on.
Read TPS Counts at both no
Not getting the above
Replace TPS (para 7-58).
throttle and full throttle.
reading.
Then go to 21-30.

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business