Click here to make tpub.com your Home Page

Page Title: DDR TEST
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 9-2320-364-20-1
Allow engine to cool before performing troubleshooting maintenance. If necessary use insulated pads
and gloves. Hot engine components will burn and cause personnel injury.
Use jumperwire only between terminals
indicated. Failure to comply may result in
damage to DDEC components or wiring.
DDR TEST
(1) Disconnect OPS harness connector.
(2) Turn ON ENGINE switch
(TM 9-2320-364-10).
(3) Select MODE 18 (OIL TEMP) on
DDR.
(4) Run engine until oil temperature
reading is greater than 140F
(60C).
(5) Is Code 36 or any other codes except
Code 35 displayed on DDR with OPS
connector disconnected.
(a) If Code 35 or any other code is
displayed, turn OFF ENGINE
switch and go to Step 5 of this
Fault.
(b) If Code 36 and any other code
except Code 35 is displayed, turn
OFF ENGINE switch and go to
Step 3 of this Fault.
(1) Loosen screw and disconnect engine
harness connector at DDEC ECM.
(2) Place jumperwire between terminals
A and B at OPS harness connector.
(3) Read resistance between wires 452
and 530 at engine harness
connector, terminals P2 and Y2.
(a) If there are more than 5 ohms
present, remove jumperwire and
repair wires 452 and/or 530
(see schematic Fig 2-2) or
notify DS Maintenance.
(b) If there are 5 ohms or less
present, wires 452 and 530
are OK.
(4) Remove jumperwire.

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business