 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-363-20-2
INSTALLATION
1.
INSTALL NEW RUBBER SEAL (15), BRACKET (17), NEW RUBBER SEAL (16), AIR HORN (10), THREE
WASHERS (14), THREE SCREWS (13), THREE WASHERS (12), AND THREE NEW LOCK NUTS (11).
WARNING
Make sure all air lines and fittings are clear of debris. Make s re excess pipe
u
sealant compound does not enter air lines or fittings. Failure to do so could
result in equipment failure and/or injury to personnel.
Sealant compounds can burn easily, can give off harmful vapors, and are
harmful to skin and clothing. To avoid injury or death, keep away from open
fire and use in well-ventilated area. If sealant compound gets on skin or
clothing, wash immediately with soap and water.
2.
COAT THREADS WITH PIPE SEALANT COMPOUND AND INSTALL ELBOW (9) AND CONNECTOR (8) IN AIR
HORN (10).
3.
CONNECT TUBE (7) TO CONNECTOR (8).
4.
COAT THREADS WITH PIPE SEALANT COMPOUND AND INSTALL ELBOW (6) AND TEE (5) IN VALVE (3).
5.
CONNECT THREE TUBES (4) TO VALVE (3).
6.
INSTALL VALVE (3), TWO SCREWS (2), AND SCREW (1).
NOTE
Follow-on Maintenance:
Install head liners (page 4-740).
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals