INSTALLATION -699580743

TM 9-2320-363-20-2

INSTALLATION

NOTE

M915A2 only: Mounting bracket is attached to bottom of crossmember, as

shown.

All except M915A2 only: Mounting bracket is attached to top of

crossmember.

INSTALL MOUNTING BRACKET (14), TWO WASHERS (13), TWO SCREWS (12), TWO WASHERS (11), AND

TWO NEW LOCK NUTS (10).

WARNING

Make sure all air lines and fittings are clear of debris. Make sure excess pipe

sealant compound does not enter air lines or fittings. Failure to do so could

result in equipment failure and/or injury to personnel.

Sealant compounds can burn easily, can give off harmful vapors, and are

harmful to skin and clothing. To avoid injury or death, keep away from open

fire and use in well-ventilated area. If sealant compound gets on skin or

clothing, wash immediately with soap and water.

COAT PIPE THREADS OF FOUR ELBOWS (8) AND CONNECTOR (9) WITH PIPE SEALANT COMPOUND.

INSTALL FOUR ELBOWS (8) AND CONNECTOR (9) ON RELAY VALVE (3).

INSTALL RELAY VALVE (3), TWO WASHERS (7), TWO SCREWS (6), TWO WASHERS (5), AND TWO NEW

LOCK NUTS (4).

CONNECT THREE TUBES (1) AND FOUR HOSES (2) TO RELAY VALVE (3).

Change 3 4-533