INSTALLATION (Cont) -699580654

TM 9-2320-363-20-2

REAR SLACK ADJUSTER AND S-CAM REPLACEMENT (CONT)

APPLY THIN FILM OF ANTISEIZE COMPOUND TO SPLINED END OF S-CAM (4).

NOTE

Position S-cam as marked during removal.

INSTALL WASHER (5) AND S-CAM (4) IN MOUNTING BRACKET (2).

INSTALL TWO WASHERS (5.1) AND SLACK ADJUSTER (6) ON SPLINED END OF S-CAM (4).

INSTALL WASHER (7) AND NUT (8) ON SLACK ADJUSTER (6).

NOTE

If repeating Installation because measurement in step 10 exceeded 0.045 in. (1.5 mm), add

one more washer than noted in step 2 of Removal.

If repeating Installation because measurement in step 10 was less than 0.005 in. (0.13 mm),

install one less washer than noted in step 2 of Removal.

INSTALL WASHERS (9) AND SNAP RING (10) ON SPLINED SHAFT OF S-CAM (4).

INSTALL CLEVIS PIN (11) IN SLACK ADJUSTER (6).

4-452 Change 3