 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-363-20-2
3.
REMOVE NUT (7) AND WASHER (8) FROM SLACK ADJUSTER (3).
4.
REMOVE SLACK ADJUSTER (3) AND TWO WASHERS (8 1) FROM SPLINED SHAFT OF S-CAM (6).
NOTE
Mark position of S-cam prior to removal.
5.
REMOVE S-CAM (6) AND WASHER (9) FROM MOUNTING BRACKET (10).
6.
REMOVE TWO SEALS (11) FROM MOUNTING BRACKET (10). DISCARD SEALS.
NOTE
Perform step 7 only if bushings are worn or damaged.
7.
REMOVE TWO BUSHINGS (12) FROM MOUNTING BRACKET (10).
CLEANING/INSPECTION
Clean and inspect all parts in accordance with Chapter 2.
INSTALLATION
NOTE
Perform step 1 only if bushings were removed.
Coat each new bushing with oil to aid in installation.
Install bushings with label ends facing each other. Install to depth of 3/8 in.
from each end.
1.
INSTALL TWO NEW BUSHINGS (1) IN MOUNTING BRACKET (2).
NOTE
Install each seal with lip facing outward.
2.
COAT OUTSIDE DIAMETER OF TWO NEW SEALS (3) WITH OIL AND INSTALL TWO SEALS (3) IN MOUNTING
BRACKET (2).
Change 3 4-451
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals