 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-363-20-2
DRIVELINES REPLACEMENT (CONT)
INSTALLATION
WARNING
Do not get under vehicle unless vehicle is supported by jack stands. To do so
could result in serious injury to personnel.
Drivelines are heavy. Use extreme caution during installation of drivelines to
prevent injury to personnel.
1.
INSTALL UNIVERSAL JOINT (1) IN FLANGE YOKE (2).
2.
INSTALL DRIVELINE (3) ON FLANGE YOKE (2).
NOTE
Make sure bearing caps are sealed against flange yoke.
3.
INSTALL BEARING CAPS (4) ON BOTH SIDES OF UNIVERSAL JOINT (1) AND FLANGE YOKE (2).
NOTE
M916A2, M917A1, and M917A1 w/MCS drivelines are not equipped with lockstraps.
4.
INSTALL LOCKSTRAP (5) AND TWO SCREWS (6) ON EACH BEARING CAP (4).
5.
TIGHTEN SCREWS (6) TO 28 LB -FT (38 N.m) FOR M916A2, M917A1, AND M917A1 w/MCS.
TIGHTEN
SCREWS TO 33-38 LB-FT (44-52 N.m) FOR M916A1.
6.
BEND TABS ON LOCKSTRAP (5) AROUND SCREWS (6).
* M916A1 ONLY
NOTE
Follow-on Maintenance:
Lubricate drivelines (Unit PMCS, TM 9-2320-363-20-1).
4-389.0 Change 3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals