 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-363-20-2
WARNING
Do not get under vehicle unless vehicle is supported by jack stands. To do so
could result in serious injury to personnel.
NOTE
M916A2, M917A1, and M917A1 w/MCS drivelines are not equipped with lockstraps
1.
BEND TABS ON LOCKSTRAPS (1) ON BOTH SIDES OF FLANGE YOKE (2) AWAY FROM SCREWS (3).
2.
REMOVE TWO SCREWS (3) AND LOCKSTRAP (1) FROM EACH SIDE OF FLANGE YOKE (2).
WARNING
Drivelines are heavy. Use extreme caution during removal of drivelines to prevent
injury to personnel.
CAUTION
Be careful when removing bearing caps, or needle bearings may fall out and be
damaged or lost
3.
REMOVE BEARING CAPS (4) FROM EACH SIDE OF FLANGE YOKE (2) AND UNIVERSAL JOINT (5).
4.
PULL DRIVELINE (6) TO ONE SIDE. PULL OUT TO REMOVE DRIVELINE (6) FROM FLANGE YOKE (2).
CLEANING/INSPECTION
Clean and inspect all parts in accordance with Chapter 2.
Change 3 4-389
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals