 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-363-20-2
NOTE
Tag and mark all wires and cables prior to removal to aid in installation.
1.
REMOVE NUT (1), LOCK WASHER (2), CABLE (3), GROUND STRAP (4), AND THREE WIRES (5) FROM
STARTER (6). DISCARD LOCK WASHER.
2.
REMOVE NUT (7), LOCK WASHER (8), CABLE (9), AND FOUR WIRES (10) FROM STARTER SOLENOID (11).
DISCARD LOCK WASHER.
3.
REMOVE NUT (12), LOCK WASHER (13), AND TWO WIRES (14) FROM STARTER SOLENOID (11). DISCARD
LOCK WASHER.
4.
REMOVE NUT (15) AND CABLE (16) FROM JUNCTION BLOCK (17).
5.
REMOVE THREE SCREWS (18), THREE LOCK WASHERS (19), AND STARTER (6).
DISCARD LOCK
WASHERS.
CLEANING/INSPECTION
Clean and inspect all parts in accordance with Chapter 2.
INSTALLATION
NOTE
If installing new starter, make sure nose housing is in same position as nose
housing on old starter. If not, both old and new starters must be sent to direct
support to have nose housing on new starter removed and reinstalled in correct
position.
1.
INSTALL STARTER (6), THREE NEW LOCK WASHERS (19), AND THREE SCREWS (18).
2.
INSTALL CABLE (16) AND NUT (15) ON JUNCTION BLOCK (17).
3.
INSTALL TWO WIRES (14), NEW LOCK WASHER (13), AND NUT (12) ON STARTER SOLENOID (11).
4.
INSTALL FOUR WIRES (10), CABLE (9), NEW LOCK WASHER (8), AND NUT (7) ON STARTER SOLENOID (11).
5.
INSTALL THREE WIRES (5), GROUND STRAP (4), CABLE (3), NEW LOCK WASHER (2), AND NUT (1) ON
STARTER (6).
NOTE
Follow-on Maintenance:
Connect batteries (page 2-29).
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals