 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-363-20-2
FUEL CYLINDER REPLACEMENT
1.
DISCONNECT BATTERIES (Page 2-29).
WARNING
Ether fuel is extremely flammable and toxic. DO NOT smoke and make sure you
are in a well-ventilated area away from heat, open flames or sparks. Wear eye
protection. Avoid contact with skin and eyes and avoid breathing ether fumes. It
can be harmful or fatal if swallowed. If swallowed, DO NOT induce vomiting. If
fluid enters or fumes irritate the eyes, wash immediately with large quantities of
clean water for 15 minutes. Seek medical attention immediately if ether is
swallowed or causes eye irritation. Failure to follow this warning could cause
death or serious injury to personnel.
2.
LOOSEN CLAMP (1) AND UNSCREW FUEL
CYLINDER (2) FROM VALVE (3). REMOVE
AND DISCARD VALVE GASKET FROM
VALVE.
3.
APPLY LUBRICATING OIL TO VALVE
GASKET AND THREADS OF FUEL CYLINDER
(2).
4.
INSTALL NEW VALVE GASKET IN VALVE (3).
SCREW NEW FUEL CYLINDER (2) INTO
VALVE AND TIGHTEN CLAMP (1).
5.
CONNECT BATTERIES (Page 2-29).
6.
TURN ON IGNITION (TM 9-2320-363-10).
7.
RED INDICATOR LIGHT (4) ON ETHER
CONTROL RELAY (5) SHOULD BE ON.
8.
RUN A MAGNET OVER PLATE (6) ON ETHER
CONTROL RELAY (5).
RED INDICATOR
LIGHT (4) SHOULD GO OFF.
Change 3 4-75.1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals