AUTOMATIC ETHER STARTING AID REMOVAL

TM 9-2320-363-20-2

AUTOMATIC ETHER STARTING AID AND FUEL CYLINDER REPLACEMENT (CONT)

AUTOMATIC ETHER STARTING AID REMOVAL

DISCONNECT BATTERIES (PAGE 2-29).

REMOVE CLAMP (1) FROM FUEL CYLINDER BRACKET (2).

WARNING

Ether fuel is extremely flammable and toxic. DO NOT smoke and make sure you

are in a well-ventilated area away from heat, open flames or sparks. Wear eye

protection. Avoid contact with skin and eyes and avoid breathing ether fumes. It

can be harmful or fatal if swallowed. If swallowed, DO NOT induce vomiting. If

fluid enters or fumes irritate the eyes, wash immediately with large quantities of

clean water for 15 minutes. Seek medical attention immediately if ether is

swallowed or causes eye irritation. Failure to follow this warning could cause

death or serious injury to personnel.

UNSCREW FUEL CYLINDER (3) FROM VALVE (4). REMOVE AND DISCARD VALVE GASKET FROM VALVE.

DISCONNECT MAIN HARNESS CONNECTOR (5) FROM ETHER CONTROL RELAY HARNESS CONNECTOR

(6).

DISCONNECT MAIN HARNESS CONNECTOR (7) FROM HARNESS CONNECTOR (8).

DISCONNECT ETHER TUBE (9) FROM FITTING (10).

NOTE

Fitting has left-hand threads. Turn right to remove, turn left to install.

REMOVE FITTING (10) FROM VALVE (4).

DISCONNECT ETHER TUBE (9) FROM CONNECTOR (11) ON INTAKE MANIFOLD.

REMOVE CONNECTOR (11) FROM INTAKE MANIFOLD.

10.

REMOVE FOUR BOLTS (12), FOUR FLATWASHERS (13), FOUR NUTS (14), AND ETHER CONTROL RELAY

(15) FROM ETHER CONTROL RELAY BRACKET (16).

11.

REMOVE ETHER CONTROL RELAY BRACKET (16) FROM FUEL CYLINDER BRACKET (2) BY REMOVING

TWO BOLTS (17), FOUR FLATWASHERS (18), AND TWO NUTS (19) ON RIGHT SIDE OF FUEL CYLINDER

BRACKET (2).

NOTE

Valve with harness attached is permanently attached to fuel cylinder bracket.

4-75.2 Change 3