|
|
TM 9-2320-360-34-2
28-5. AUXILIARY WINCH REPAIR (CONT)
(10) Install thrust washer (18) on shaft portion
of secondary carrier assembly (19).
(11) Install secondary carrier assembly (19),
shaft first, on ring gear (12) until flush.
NOTE
Sun gear is installed with beveled
teeth out.
(12) Install sun gear (20) in secondary carrier
assembly (19).
(13) Install new preformed packing (21) on
shifter shaft (22).
(14) Install shifter shaft (22) in end cover (2).
(15) Install knob (23) on shifter arm (24) with
new lockwasher (25) and screw (26).
(15.1) Install new preformed packing (26.1) and
new preformed packing (26.2) on end
cover (2).
WARNING
Spring is under pressure when
compressed.
Use care when
installing to prevent serious injury.
NOTE
Arrow on shifter shaft should point in
same direction as shifter arm.
(16) Install shifter arm (24) on shifter shaft (22)
with washer (27), spring (28), and
sockethead screw (29).
(17) Install new preformed packing (30) on end
cover (2).
NOTE
Ensure groove around drive coupling
engages boss on shifter shaft.
(18) Install drive coupling (31) in end cover (2).
NOTE
Shifter arm must be turned so drive
coupling lays flat in end cover.
(19) Turn shifter arm (24) 180 degrees so knob
(23) faces outside end cover (2).
28-56 Change 1
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |