Disassembly (Cont.) -726030487

TM 9-2320-360-34-2

27-5. TEE GEAR BOX REPAIR (CONT)

(23) Remove locknut (27) from pinion shaft (3).

Discard locknut.

(24) Position pinion shaft (3) gear side up in suitable

press.

CAUTION

Protect shaft from striking floor while

pressing gear from shaft. Failure to

comply may result in damage to

shaft.

(25) Press pinion gear (28) from pinion shaft (3).

(26) Remove woodruff key (29) from pinion shaft (3).

(27)

Position pinion end plate (7) with pinion shaft

(3) threaded end up in suitable press.

CAUTION

Protect shaft from striking floor while

pressing from pinion end plate.

Failure to comply may result in

damage to pinion shaft.

(28) Press pinion shaft (3), bearing cone (30), and oil

seal (31) from pinion end plate (7). Discard oil

seal.

(29) Position pinion shaft (3) threaded end up in

suitable press.

WARNING

Wear eye protection and use care

when removing retaining rings.

Retaining rings are under spring

tension and can act as projectiles

when released causing severe eye

Injury.

NOTE

Some tee boxes have machined

shoulder on shaft and no retaining

rings. Skip steps (30) if no retaining

ring is present on shaft.

(30) Remove retaining ring (32) from pinion shaft (3).

Discard retaining ring.

(31) Press outer bearing cone (30) from pinion shaft

(3).

(32) Remove inner bearing cone (33) and two

bearing cups (34) from pinion end plate (7).

27-44 Change 1