TEE GEAR BOX REPAIR (cont)

TM 9-2320-360-34-2

(12) Remove oil seal (18) from rear output end plate

(14). Discard oil seal.

(13) Position rear output end plate (14) in vise

outside surface up.

(14) Remove bearing cup (19) from rear output end

plate (14).

(15) Remove rear output end plate (14) from vise.

NOTE

Some tee boxes have machined

shoulder on shaft and no retaining

rings. Skip steps (16) and (19) if no

retaining rings are present on shaft.

(16)

Remove retaining ring (20) from locking position

and slide toward gear (21) on output shaft (2).

(17)

Position output shaft (2) gear side down in

suitable press.

CAUTION

Protect shaft from striking floor while

pressing bearing and spacer. Failure

to comply may result in damage to

output shaft.

(18)

Press bearing (22) and spacer (23) from output

shaft (2).

WARNING

Wear eye protection and use care

when removing retaining rings.

Retaining rings are under spring

tension and can act as projectiles

when released causing severe eye

injury.

(19)

Remove two retaining rings (20 and 24) from

output shaft (2). Discard retaining rings.

(20)

Position output shaft (2) gear side up in suitable

press.

CAUTION

Protect shaft from striking floor while

pressing bearing and gear. Failure to

comply may result in damage to

output shaft.

(21) Press bearing (25) and gear (21) from output

shaft (2).

(22) Remove woodruff key (26) from output shaft (2).

Change 1 27-43