Assembly (Cont.) -726030480

TM 9-2320-360-34-2

(9) Position bearing cap (4) in vise with outside.

surface facing up.

NOTE

Seals are Installed lip-side out.

(10) Install new seal (9) in bearing cap (4) until it

rests against high-pressure seal (5).

(11) Install new seal (10) in bearing cap (4) until flush

with face of bearing cap (4).

(12) Remove bearing cap (4) from vise.

(13) Lubricate piston (11) with hydraulic oil and install

in housing (2).

NOTE

Do steps (14) thru (16) if pinion gear

or shaft was removed.

(14) Position pinion gear (12) on output shaft (13).

(15) Install retaining pin (14) through hole in pinion

gear (12) into slot on output shaft (13).

(16) Install roll pin (15) in pinion gear (12).

27-37