 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-34-2
27-2. STEERING PUMP REPAIR (CONT)
(14) Install spring washer (30), spring (31), and
spring washer (32) in cylinder block (33).
(15) Position four washers (34), screw (35),
and nut (36) through cylinder block (33).
NOTE
Tighten nut only enough to install
retaining ring.
(16) Tighten nut (36) to compress spring (31).
WARNING
Wear eye protection and use care
when installing retaining rings.
Retaining rings are under spring
tension and can act as projectiles
when released causing severe eye
injury.
(17) Install retaining ring (37) in cylinder block
(33).
(18) Remove nut (36), screw (35), and four
washers (34) from cylinder block (33).
NOTE
Pin retainer must be installed 0.25 in.
(6.4 mm) below surface.
(19) Install pin retainer (38) in cylinder block
(33).
NOTE
Pins must be installed in cylinder
block until they bottom against
spring washer.
(20) Install three pins (39) in cylinder block
(33).
(21) Position spherical washer (40) on top of
three pins (39).
(22) Install shoe plate (41) with nine pistons
(42) over spherical washer (40) and into
cylinder block (33).
27-20
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals